After the introduction and analysis of two op-amp based guitar boosters, let’s see how they sound. I’ll breadboard them and try them out to make sure everything works as expected. I’ll give some effect characteristics, do a breadboarding diagram, then do the actual breadboarding (with bill of material) and finally test both effects out. Characterizing […]
I went through schematics for MXR Micro Amp and my Thunder, so now I’ll go through some SPICE analysis for them. I said the circuits are similar and should have pretty similar sound. Let’s see how they look when simulated and if we can learn anything. Schematics Here are the schematics in SPICE: The schematics […]
In this final build, when it comes to simple booster effects, I am going to use Op-Amps. An op-amp is an integrated circuit (a chip) containing several transistors inside of it to achieve a very large gain. But it does so in a way that makes amplifier design very consistent and predictable. In this post […]
I finished building a simple JFET booster over the weekend. I had to do some extra designing of a JFET amplifier to make it boost since the breadboarded version wasn’t boosting the signal. The design is only slightly more complex than previous efforts. You can check out the dedicated build page here.
The next in line for building is a JFET Booster. I chose a Fetzer Valve circuit. This one is a bit different, I had to go through measuring my JFET components and then go through calculating correct component values. I then breadboarded it in two different versions. It was interesting, something different, check it out.
I finished building a simple MOSFET booster today. Simple but effective pedal, clean boost with flat response and great input/output characteristics. Or check out dedicated build page for it.
I started building a simple MOSFET booster this time. BJT booster is done, and now something a bit different, but similar enough :). I chose AMZ Mosfet Booster. I’ve done analyzing it and breadboarding it, so have a look.
And this is it, finally, the pedal is finished. After breadboarding it, then experimenting some with the effect, settling for final list of components to use, last time I finished the enclosure. Today, I soldered it and finally assembled it into it’s final form. Check it out.
After testing it and experimenting with simple booster pedal, I decided which components to use. Now is time to finally start putting everything together. Lets prepare some colourful enclosure for this pedal. Check it out.